Building the templates for the frames

I decided to make templates from the plans for most of the parts in the frames. Using the carbon paper, lines were traced onto material to make the templates. The actual frame pieces were then rough cut, stacked together with double backed tape, the templates double-back taped to the pieces and a trimming router bit with guide bearing used to cut multiple pieces at the same time. In the corners where 1/4" plywood gussets were used, 4 indenticle parts were made at the same time.

With African Mohogany purchased from Armstrong Millworks in Highland Michigan and Okoume plywood purchased at Public Lumber in Detroit, the frame build got started. The same layout board was used as an assembly jig. Blocks were screwed down to locate frame members so that epoxy gluing, screwing and or nailing could be done while maintaining alignments.

Related Posts by Categories