Some Good people at Eurofab Technologies Ltd. are to bend it on a press brake.
www.eurofab.ie
There was a smaller test piece also marked up for the setup
12th Feb we get a clear hour to do the bend as the factory is usually busy doing lots of repeat work.
First test piece 90 % correct.
We also did a piece only 2mm thick to get the bend radius correct.
Final piece ready to get bent. I had the sheet marked at 22 degree intervals, we decided that more hits at 11 degrees would give a better shape.
All setup to go. 1 piece and 1 go. !!!
The Boys werent worried.....
Naturally the piece is 100% perfect. 270 mm Dia at the top and 110mm at the bottom.
Better than I expected.
0 komentar:
Posting Komentar